الأنابيب الملفوفة Hydraulic Tubing Cutting Case
The XH-243X well is an HPHT deep standard well with a measured bottom depth of 5690 m, maximum temperature of 165.96 °C, formation pressure of 58.98 MPa, and maximum inclination of 20.24°. وكان الهدف من العمل هو خفض 2.875 في P110 مستاء من الحوض قاع البئر.
التحدي
وقد أدى العمق الجيد ودرجة الحرارة والضغط إلى ارتفاع الطلب على استقرار الأدوات وخفض الموثوقية. The target tubular was 2.875 in P110 off tubing, and the operation required stable anchoring, controlled internal cutting, and a reliable withdrawal-out condition after the cut.
Tool String
The cutting BHA from top to bottom included a 50.8 mm dimple connector, crossovers, 43 mm check valve, 44 mm hydraulic anchor, crossover, 54 mm محرك طيني, crossover, and 44 mm hydraulic cutter. ووفرت المرساة الاستقرار أثناء القطع، في حين قام المقطع بقطع الحوض الداخلي.
العملية
The الأنابيب الملفوفة was run to 5372.82 m and encountered resistance near the circulation sleeve. ثم سحب حتى 5360.31 متراً للقطع. A 1.33 g/cm3 CaCl2 liquid was used, with flow rate of 60-130 L/min. وبلغ مجموع وقت التخفيض 90 دقيقة، وتراوحت ضغوط القطع من 12.4 إلى 32.4 ميغاواط.
النتيجة
After the سلسلة الأدوات was drag out, cutter blade extension was check at approximately 13 mm and 16 mm. The إصلاح الآبار unit performed a 55 T withdrawal test, the tubing was recovered, and the cutting operation was successful. وتظهر القضية مرساة هيدروليكية من طراز ASBR، وأداة متقطعة في تطبيقات قطعية من طراز HPHT الأنابيب الملفوفة.